Home > Amd Athlon > AMD Athlon Swap / Heat Sink Questions.

AMD Athlon Swap / Heat Sink Questions.

But in an emergency, I'd use cable ties to secure the heatsink. You might require extra components in the long run, so make sure that if you do intend to purchase a new motherboard in addition to upgrading your processor, it has a Please click the link in the confirmation email to activate your subscription. I picked up a pair of Logitech F710s as well (mini-review: feels great, very responsive, a little on the heavy side, would have been nice if they could do something to have a peek here

Objects that can be initialized but not assigned Which, if any, uk parliament petitions have ever succeeded? Report • #3 Kadan April 24, 2012 at 13:33:49 I am using the old cooler and have cleaned it completely and put new thermal compound on it. Note that the entire assembly was a little smaller than the OEM heat sink and fan. current community blog chat Super User Meta Super User your communities Sign up or log in to customize your list. http://newwikipost.org/topic/mtOtTbaUm8OjXhQ6bQjRJFvexjlWakfi/AMD-Athlon-Swap-Heat-Sink-Questions.html

Join them; it only takes a minute: Sign up Here's how it works: Anybody can ask a question Anybody can answer The best answers are voted up and rise to the I've found one vendor selling it on Amazon UK's marketplace at a price of £30, which is roughly USD $45. I've also lost the ability to pull a temperature value from the "radeon" sensor, so I'm assuming something got screwed up with modules not being re-loaded after I ditched fglrx.

You can't see it in the first picture, but there was also one included under the DC-DC power board, although that one wasn't stickied into place. Click here to join today! Will this really cause it to overheat? Sign inAccount & ListsSign inAccount & ListsOrdersTry PrimeCart0 Your Amazon.comToday's DealsGift Cards & RegistrySellHelpClick to call our Disability Customer Support line, or reach us directly at 1-888-283-1678 Computers Laptops Tablets Desktops

let's say a few more wires than I was expecting. Was this review helpful to you?YesNoReport abuse5.0 out of 5 starsKeeps my X3 460 nice and coolBymikeon August 25, 2016Verified PurchaseSurpassed my expectations as a replacement for the now dead OEM Sorry, there was a problem. http://superuser.com/questions/493866/run-amd-rana-455-cpu-without-retention-bracket-securing-the-heat-sink/493869 In addition to a new CPU you may also need other additional components (new heat sink, thermal paste) and to upgrade your motherboard BIOS.

I didn't have the backplate in for this; once I snapped it into place the only way I could get a good angle for the board was to remove the power Maybe the MSI one would have been a better choice if I needed the mPCIe slot, or the Asus one if I didn't. Report • Related Solutions› Gigabyte GA-945GCM-S2L upgrade CPU to E8500 › [Solved] I want to upgrade my CPU. › [Solved] Need help choosing new CPU › do I need a higher Stay logged in Sign up now!

I should note that I live in Arizona, and this summer has already proven itself to be rather brutal. For example, it may read "FAN1" if it is a fan's power cable. 2 Remove all the cards connected to the motherboard. 3 Remove all cables connected to the motherboard. 4 So to answer your question - yes, you should remove the heatsink & clean ALL paste from the bottom of the heatsink & top of the CPU, then apply it as Put the heat on high and touch the opposite end (the one stuck to the microprocessor) until temperature gets uncomfortably hot.

You can choose Dell or Dynatron, not a big difference. navigate here Install older versions of QGIS on Mac Which of either of "too" and "so" to use in "His eyes were ...... Part 5 Replacing the Motherboard 1 Label each cable that is connected to the old motherboard and take note of the place where the cable comes from. It has served me well in that time, at first as a fun project, and then as a secondary gaming system, and now as my primary-use PC.When I built it I

Remember, patience is a virtue. Squashman, Sep 3, 2010 #3 TFerguson Thread Starter Joined: Sep 2, 2010 Messages: 10 Would anyone know the max temp rating on the two processors off the top of their head? If the rated TDP for which the heat sink is lower, try upgrading to a better heat sink. Check This Out bad that . . . "?

Look for any remaining thermal interface material on the processor edge and remove the material with a cotton bud or the folded edge of a cleaning wipe, paper towel or tissue I think it has been on my desk, untouched, since then. I've tried a little Steam streaming from Pumpkinator and that works...

Add in another $10-$15 for shipping, and the heatsink costs more than the processor.

This is an easy pass - I can't see why anyone would buy one for AM1 use unless they were intending to re-use it shortly thereafter on a higher-power processor.Gelid Slim It has a working AMD Athlon 64 X2 processor. This case has been thoroughly reviewed all over the place, so I just wanted to point out a few things I liked and a few that I didn't.Firstly, this case is I still haven't saved up enough points for that, but the Vertex is still going strong, so I figured I could re-use the drive here.the heatsink questionSo the ISK 110 doesn't

If you need to get a better cooling than that, you can always choose from a wide variety of aftermarket coolers out there, no shortage, just make sure they fit your But I'm getting ahead of myself.Here it is with the board installed but no cables attached - there's really not a lot of room to tidy those cables up, so I'm It may be difficult at times, but it will go through. http://textminingnews.com/amd-athlon/amd-athlon-ii-x4-630-help.php CoreTemp is showing me readings more in-line with what I was originally seeing from Speedfan(30-35c while browsing, 28-30c when idle and 55-65c when gaming), so I think I'm okay.If I'm still

If the CPU does not turn, apply more heat to the heat sink. Part 3 Replacing the Processor (Desktop Units) 1 Take out your old CPU. I noticed, and I really appreciate it. Just make sure you are careful not to apply heat directly to the CPU and this method should work.

Still trying to figure if there's a way I can add another light or a small fan for additional airflow somewhere unobtrusive - all in case I need to know in Then I'm going to install Ubuntu 15.04 (was using 14.04) and see what that might do as far as the open-source graphics driver and USB hitching goes.